This is the most cost effective front loader solution for loading/unloading your machine tools. It utilizes a single pallet with a higher speed robot for the fastest chip-to-chip cycles. Easy access to machine tool through sliding door with machine tool controls always accessible. Will accommodate most machine tools. Parts can be vertical or horizontal.

View Configuration Options
Get Automation Estimate
 
  • Can be easily accommodated to load/unload virtually any machine tool - lathes, mills, grinders, EDMs, etc.
  • Handles all spindles up to a 20" operator reach, and from 30" to 45" high
  • Works with left hand (L) or right hand (R) controls on machine tool
  • Complete access to most machine tool control panels while in operation
  • FANUC LR Mate 200iD/7L robot for small to medium sized parts. Robot capacity is 7Kg including end effector.
  • Robot collision guard software option
  • Cell is designed to require minimal floor space but will allow access to the front of the machine tool - no sliding equipment away to service machine tool. Safety interlocked guarding door allows complete access to machine tool or automation cell
  • Safety guarding around robot cell - meets RIA & OSHA safety standards
  • Parts can be vertical or horizontal in pallets, with vertical arrangements offering large part quantities per pallet
  • Single gripper (EOAT) is provided with blank jaws - see "OPTIONS" for different configurations.
  • One 13" x 13" pallet holds 100 parts on a 1" x 1" pattern - can configure for your parts.
  • Easy access for loading/unloading pallet
  • User friendly programming with the FANUC robot
  • Easy to adapt for different work pieces
  • Cell is assembled, programmed, and tested before delivery using generic pallets, parts, and EOAT
  • Guaranteed JH Robotics & FANUC support
  • Operator training and runoff at JH Robotics included in price
  • Field retrofits available in many cases
  • Various alternative input/output solutions available upon request. (conveyors, gravity chutes, bowl feeders, etc.)
  • Pallets can be machined on both sides for different parts
  • Pallet can be reversed end for end for an OP10 to OP20 reload for axis horizontal parts
  • Turnkey automation for your parts (suggested for first time purchasers) - NO metal cutting unless by separate order
  • Dual gripper (EOAT) for simultaneous load/unload (Can use 20 lb payload for double grip configuration when doing the load/unload and when end effector has both parts - FANUC 10kg option)
  • Dual linear 2-jaw assembly for gripping parts on the diameter - parts horizontal in pallets
  • Dual 3-jaw assembly for gripping parts on end - parts vertical in pallets
  • Dual rotating gripper for reversing parts to machine the opposite end
  • Automatic end effector changeover if applicable
  • Can accommodate secondary operations based on cycle times such as washing, inspecting/gauging, deburring, component assembly, labeling or vision systems
  • For longer reach for secondary type operations a FANUC M-10iA robot can be utilized
  • Light tower for the cell
  • A second shelf can be added above the first shelf to double the capacity. This depends on part type, etc.
  • Additional setups, training, etc. at your facility

 

Copyright © - JH Robotics, Inc.

Scroll to Top